![]() ![]() BBB asks third parties who publish complaints, reviews and/or responses on this website to affirm that the information provided is accurate. I will NEVER buy a T-REX product ever again.īBB Business Profiles may not be reproduced for sales or promotional purposes.īBB Business Profiles are provided solely to assist you in exercising your own best judgment. I have filed a complaint with the Attorney General's office and hopefully will get some resolution with this. All they said is that they are waiting on the old parts to be sent back, but I explained that they shipped the wrong ones to begin with. Till this date there has been nothing form their department. I even had to pay the shop for the unfinished repair time, since no one new they were the wrong lights until the grill was fully taken off. I have been in an email battle with them arguing that they have sent the wrong parts. The last email received by them was on, I replied and have 0 response. We are now over 1 year and 6 months past purchase date, still no parts or emails back from them. I contact T-Rex again and have been in email back and forth explaining the situation. From there it took over 1 year to get the replacement LED bar, and it was the wrong part. There was an issue with a LED bar that had water in it, and a orange LED that was out, so I contacted Mobile Music who email T-Rex for warranty replacement parts. This grill is supposed to have a LifeTime Limited Warranty. * Always observe all applicable precautions and follow good safety and hygiene practices.I purchased a grill from Mobile Music Bellingham, who ordered the grill through T-Rex. In the event of injury, see first aid procedures on MSDS. * Wear appropriate PPE such as eye and skin protection. Be sure employees are adequately trained on the safe use of respirators per company and regulatory * Provide adequate ventilation for health and fire hazard control.įollow company, product MSDS and respirator manufacturer’s recommendations for selection and proper use of respiratory protection. * Follow spray equipment manufacturer’s instructions to prevent personal injury or fire. * Improper handling and use, for example, poor spray technique, inadequate engineering controls and or lack of Personal Protective Equipment (PPE), may result in hazardous conditions or injury. The mixture will have the hazards of all its parts. Before opening the packages, be sure you understand the warning messages on the labels and MSDS’s of all components, since The contents of this package may have to be blended with other components before the product can be used. See Material Safety Data Sheet and labels for additional safety information and handling instructions. ![]() Regular duty: 5 days at 70 degrees F / 20 degrees C. Light duty: 2 days at 70 degrees F / 20 degrees C. Touch Dry at 70 degrees F / 20 degrees C : 1 hour subject to film build. Usable Pot life at 70 degrees F / 20 degrees C : 60 minutes After a 2 minute flash, apply a very light 2nd coat, sprayed at 80 PSI, using a fast sweeping motion. Apply a uniform wet coat of bed liner using a sweeping motion.Ħ. Adjusting the air pressure (60-80 PSI) and spray distance will change the texture.ĥ. Remove the cap and screw in the Shutz Spray Gun.Ĥ. Screw on quart bottle cap and shake for two minutes.ģ. Add 8 ounces of SMR-222 activator to a quart bottle of SMR-1000.Ģ. Instructions: Apply Bed Liner between 60 - 85 degrees F and humidity less than 70%, Not in direct sunlight.ġ. Re-clean with wax and grease remover, then dry with a clean towel. Scuff surface with 180-220 grit sandpaper. Thoroughly clean area with Wax and Grease Remover. Wash area with soap and warm water, then rinse and dry. Surface should be cleaned of all grease, oil, dirt, rust, etc before sanding.
0 Comments
Leave a Reply. |